Western Telematic MT5634 Uživatelská příručka

RPS-10 SeriesExpandable Remote AC Power SwitchesModels Covered:RPS-10 Standard UnitRPS-10 HD Heavy Duty UnitRPS-10 EC 220/230 VAC UnitUser's Guid

3.6. Test for Proper InstallationAfter installation, the following test should be performed to make certain all modules areoperating correctly.1. Esta

4. OperationEach RPS-10 module can be switched or toggled by an ASCII command string sent to theMaster Module control port. The Control Device must se

Examples:To toggle the Switched AC Outlet on the RPS-10 Module at Address "3", send the followingcommand:^B^X^X^B^X^X3T^MTo set the Switched

4.1. Optional Accessories4.1.1. Three Module RackWTI offers an optional three module rack, which fits most standard instrument racks. Toassemble the r

4.1.2. Snap AdaptersWTI offers a complete selection of snap adapters and cables designed to simplify connectionbetween the RPS-10M Master Module and y

4.2. Cable Wiring DiagramsPage 13RPS-10 Series Remote Power Switches, User's Guide OperationFigure 8: Cable Wiring Diagram; RPS-10 to ModemFigure

A. SpecificationsSwitched Outlet / Terminal Block:RPS-10: 1 Plug, Rated at 115 VAC @ 10 Amps Max.RPS-10 HD: 1 Plug, Rated at 115 VAC @ 15 Amps Max.RPS

B. FCC Statement:This device complies with part 15 of the FCC Rules. Operation is subject to the following twoconditions:1. This device may not cause

Table of Contents1. Introduction...12. Unit Description...22.1. Fr

1. IntroductionNetwork equipment sometimes "locks-up", making it impossible to communicate. In the past,this situation required a trip to th

2. Unit Description2.1. Front PanelÀAC ON: Lights when power to the Switched Outlet is ON.Á LINK: Flashes when command data is received. RDY: Lights

2.2.2. RPS-10 EC Back Panel2.3. Back Panel ComponentsÀSwitched Outlet: (RPS-10, RPS-10 HD, and RPS-10 EC) For connection to your ACpowered device (see

3. InstallationThe installation procedure consists of the steps listed below. For more information, pleaserefer to the section(s) indicated.1. Set the

3.2. Set-Up SwitchesPrior to connecting AC power to the RPS-10 Modules, configure the Set-Up Switches on eachmodule according to the requirements of y

3.3. Linking ModulesConnect straight wired RJ11 cables between the Link Ports to link the RPS-10 Master Moduleand Satellite Modules as shown in Figure

3.4. Control Port ConnectionThe RS232 Control Port is a male, DB9 connector, used for connection to a PC or externalmodem. The Control Port employs a